These adapters allow you to easily covert barrel power connectors to bare wires.
The typical uses for these are as follows
- Male: The barrel end connects to a normal power supply. Then, you may connect the bare wires to a cable or wiring of some sort. Normally the bare ends would connect to to Siamese cable or 18/2 cable
- Female: The barrel end connects to the camera's power jack. Then, you may connect the bare wires to a cable or wiring of some sort. This would normally be to a Siamese cable of some sort as well.
If you were to use these to extend the power source away from a camera, then you would have the power supply connected to the 3Led male connected to the cable connected to the 3Led female connected to your camera.
- 12V-Wire: This is primarily designed for 12 volt automotive applications. One end is bare wire in order to hard wire to battery or splice into automotive system. The other end has the standard female plug to connect directly to one of our 12 volt surveillance cameras or a 12 volt DVR such as the 4E12VR. The 12V-Wire also has a diode built in to protect against reverse polarity and voltage spikes.
Specifications
- Barrel Inner Diameter: 2.1mm
- Barrel Outer Diameter: 5.5mm
- Barrel Polarity: Center Positive
